• 6 juni 2018 om 19:45 #6202
      Marcel van Dijk
      Moderator

      This thread serves as communication for our new 3D printer, the Craftbot plus.

      So far, the printer works as advertised:
      – start the slicer ‘Craftware’ on the right-most PC of the 3D -printer table.
      – load your model in STL format
      – slice your model
      – save the result in GCode on a USB-stick
      – start the printer (switch on lower back side)
      – put the USB-stick in the slot on the front top of the printer
      – start the print via the menu

      The result is surprisingly good, so far.

Je moet ingelogd zijn om een reactie op dit onderwerp te kunnen geven.