• 21 november 2018 om 22:24 #6706
      Anoniem
      Inactief

      Tried to use the lasercutter today, but keeps making the wrong tests and keeps hitting itself up to the upper side of the bed?

      Any suggestions?

    • 15 december 2018 om 21:19 #6767
      MvDalsAdmin
      Sleutelbeheerder

      Likely the starting point (laser origin ?) was changed from upper right to upper left. That interferes with the ’toontooring’ testing of the job contours. I changed it back – using the Lasercut software. I will report back how exactly.

Je moet ingelogd zijn om een reactie op dit onderwerp te kunnen geven.