In this calendar, the laser cutter can be reserved. Reservations can be made for the opening hours od the Starthub building. During the day the door is open, outside office hours and on weekends, you need a WUR-access pass. The FabLab has some access cards which you can obtain from the board. outside office building is open until the evening 22:00, then turned on the alarm through security and you should have left the building (Note that the calendar defines no end time).

PLEASE NOTE: AT 17:30 THE VENTILATION TOTALLY STOPS !    SO LASER ONLY UNTIL 17:15 !!!

The reservation is included in the calendar, but the FabLab at all times reserves the right to cancel a reservation if this is not possible.

Key management is not finalised yet (thank you, Kandans and WUR ;-(
This will be communicated later, sorry.

The key lies in the safe in the office at the entrance. It is the large cabinet on the left and the code is known to the fabmembers. It only grants access to the fablab itself and not the outside door of the building.

January 2021

  • Monday
  • Tuesday
  • Wednesday
  • Thursday
  • Friday
  • Saturday
  • Sunday
  • 28 December
  • 29 December
  • 30 December
  • 31 December
  • 1 January
  • 2 January
  • 3 January
  • 11 January
  • 12 January
  • 13 January

    13:30-16:00: Marcel (v Dijk) lasert voor Sam Soekhram.

    13:30-16:00: Marcel (v Dijk) lasert voor Sam Soekhram.
  • 14 January

    10:00-11:22: Chris Beem

    10:00-11:22: Chris Beem
  • 15 January
  • 16 January
  • 17 January
  • 18 January

    14:00-18:00: lasersnijden

    14:00-18:00: lasersnijden
  • 19 January
  • 20 January

    13:30-16:00: Marcel (v Dijk) lasert voor Sam Soekhram.

    13:30-16:00: Marcel (v Dijk) lasert voor Sam Soekhram.
  • 21 January

    14:00-16:00: micro-oranizer

    14:00-16:00: micro-oranizer
  • 22 January

    10:00-11:30: laseren bouwpakketjes

    10:00-11:30: laseren bouwpakketjes
  • 23 January

    16:30-17:00: Cut Project

    16:30-17:00: Cut Project
  • 24 January

Om een machine te kunnen reserveren moet je ingelogd zijn.