In this calendar, the laser cutter can be reserved. Reservations can be made for the opening hours od the Starthub building. During the day the door is open, outside office hours and on weekends, you need a WUR-access pass. The FabLab has some access cards which you can obtain from the board. outside office building is open until the evening 22:00, then turned on the alarm through security and you should have left the building (Note that the calendar defines no end time).

The reservation is included in the calendar, but the FabLab at all times reserves the right to cancel a reservation if this is not possible.

The key lies in the safe in the office at the entrance. It is the large cabinet on the left and the code is known to the fabmembers. It only grants access to the fablab itself and not the outside door of the building.

March 2020

  • Monday
  • Tuesday
  • Wednesday
  • Thursday
  • Friday
  • Saturday
  • Sunday
  • 24 February
  • 25 February
  • 26 February
  • 27 February
  • 28 February

    13:30-15:30: Marcel v Dijk lasert voor Sam Soekhram

    13:30-15:30: Marcel v Dijk lasert voor Sam Soekhram
  • 29 February
  • 1 March
  • 2 March
  • 3 March
  • 4 March
  • 5 March

    15:15-16:45: Vormen snijden

    15:15-16:45: Vormen snijden
  • 6 March
  • 7 March
  • 8 March
  • 9 March
  • 10 March

    14:30-15:30: poot

    14:30-15:30: poot
  • 11 March
  • 12 March
  • 13 March
  • 14 March
  • 15 March
  • 16 March
  • 17 March
  • 18 March
  • 19 March
  • 20 March
  • 21 March
  • 22 March
  • 23 March
  • 24 March
  • 25 March
  • 26 March
  • 27 March
  • 28 March
  • 29 March
  • 30 March
  • 31 March
  • 1 April
  • 2 April
  • 3 April
  • 4 April
  • 5 April

Om een machine te kunnen reserveren moet je ingelogd zijn.